Aspects USS60030LBNWS Guía de instalación
Busca en linea o descarga Guía de instalación para No Aspects USS60030LBNWS. Aspects USS60030LBNWS Installation Guide Manual de usuario
- Pagina / 1
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Wall Fixture
Model: 326964 &
USS60030L
1 of 1
Limited Factory Warranty
American Fluorescent Corporation warrants this fixture is
for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of de
not cover failure due to improper installation, misuse, mishandling or damage incurred in transit
Safety Precautions
Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with
instructions could result in potentially fatal electric shock and/or
property damage.
It is recommended that a qualified
fixture must be wired in accordance with all national and local
electrical codes.
Do not
handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.
ASSEMBLY INSTRUCTIONS
1.
Preparing for installation
A.
Disconnect electrical power
B. Carefully
remove the fixture from the carton, and check that all parts are included, as shown in figure below. Be
careful not to misplace any of the screws or parts which are needed for installing the fixture.
2. Wiring-
all wiring must take place inside junction
Caution:
Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power
supply wires are within three inches of
Note:
Most dwellings built before 1985 have supply wire rated to 60C. Consult a qualified electrician before
installing.
A. Install two (3
) screws (supplied) on gem bar (
(supplied)
leaving about 1 ½” length exposed from gem
bar surface
. Secure these screws wit
B.
Install gem bar on the junction box by securing it
with two (1) screws (supplied)
C. Make all
wire connections
Secure with wire nuts
(supplied
D. Connect the green wire
s
source to the green screw on the gem bar (
E.
The black wire from the fixture is connected to the
black wire from power source.
F.
The white wire from the fixture is connected to the
white (neutral) wire from power source.
G.
Tuck all connections neatly into junction box.
3. Mounting
A. Install backpan (5
) on the wall by inserting two
screws (3) through two
backpan mounting holes
the backpan
with two thumbnuts (
4. Shade-
To install the shade
diffuser with two holes on
bracket
with two decorative screws
5.
Restore power at fuse or circuit breaker box.
USS60030L
American Fluorescent Corporation warrants this fixture is
free from defects in materials and workmanship when installed and used under normal operating conditions
for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of de
not cover failure due to improper installation, misuse, mishandling or damage incurred in transit
Safety Precautions
Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with
these
instructions could result in potentially fatal electric shock and/or
It is recommended that a qualified
electrician perform all wiring. This
fixture must be wired in accordance with all national and local
handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.
ASSEMBLY INSTRUCTIONS
Preparing for installation
Disconnect electrical power
at fuse or circuit breaker box before installing or servicing any part of this fixture.
remove the fixture from the carton, and check that all parts are included, as shown in figure below. Be
careful not to misplace any of the screws or parts which are needed for installing the fixture.
all wiring must take place inside junction
box.
Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power
supply wires are within three inches of
the ballast power supply
, use wire suitable for at least
Most dwellings built before 1985 have supply wire rated to 60C. Consult a qualified electrician before
) screws (supplied) on gem bar (
2)
leaving about 1 ½” length exposed from gem
. Secure these screws wit
h two (4) nuts.
Install gem bar on the junction box by securing it
with two (1) screws (supplied)
wire connections
to appropriate wire.
(supplied
).
s
from the fixture and power
source to the green screw on the gem bar (
2).
The black wire from the fixture is connected to the
black wire from power source.
The white wire from the fixture is connected to the
white (neutral) wire from power source.
Tuck all connections neatly into junction box.
) on the wall by inserting two
backpan mounting holes
. Secure
with two thumbnuts (
8) (supplied).
To install the shade
(9) align two holes on the
bracket
(6). Secure shade
(7) (supplied).
Restore power at fuse or circuit breaker box.
LED Wall Sconce
120VAC / 60Hz
free from defects in materials and workmanship when installed and used under normal operating conditions
for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of de
fective fixture or compone
not cover failure due to improper installation, misuse, mishandling or damage incurred in transit
This fixture is designed for use in a 110
-
Do not use on a dimming circuit.
To reduce the
risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green)
between
this fixture and the ground connection of your main power
supply panel.
This fixture is intended to be used for general
locations only.
at fuse or circuit breaker box before installing or servicing any part of this fixture.
remove the fixture from the carton, and check that all parts are included, as shown in figure below. Be
careful not to misplace any of the screws or parts which are needed for installing the fixture.
Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power
, use wire suitable for at least
90C (194F).
Most dwellings built before 1985 have supply wire rated to 60C. Consult a qualified electrician before
LED Wall Sconce
8060657 R3
free from defects in materials and workmanship when installed and used under normal operating conditions
fective fixture or compone
nts; it does
-
120VAC, 60Hz fused circuit.
risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green)
contact
this fixture and the ground connection of your main power
This fixture is intended to be used for general
indoor lighting in dry
at fuse or circuit breaker box before installing or servicing any part of this fixture.
remove the fixture from the carton, and check that all parts are included, as shown in figure below. Be
Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power
90C (194F).
Most dwellings built before 1985 have supply wire rated to 60C. Consult a qualified electrician before
1
Indice de contenidos
Pagina 1 - Wall Fixture
Wall Fixture Model: 326964 & USS60030L 1 of 1 Limited Factory Warranty American Fluorescent Corporation warrants this fixture is for a period o
Relacionado con productos y manuales para No Aspects USS60030LBNWS
No Aspects QSS60030LBNWF Guía de instalación
(1 paginas)
(1 paginas)
No Aspects TPUW70050LWH Guía de instalación
(1 paginas)
(1 paginas)
No Aspects TPDW213RBPLT Guía de instalación
(1 paginas)
(1 paginas)
No Aspects TPFW70050LWH Guía de instalación
(1 paginas)
(1 paginas)
No Aspects TH7030030LWH Guía de instalación
(8 paginas)
(8 paginas)
No Aspects SWP113SCT Guía de instalación
(1 paginas)
(1 paginas)
No Aspects TPFW113WHPLT Guía de instalación
(1 paginas)
(1 paginas)
No Aspects SWP313SCT Guía de instalación
(1 paginas)
(1 paginas)
No Aspects SWC313SCT Guía de instalación
(1 paginas)
(1 paginas)
No Aspects BWSW70050LBK Guía de instalación
(1 paginas)
(1 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.092 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales